BLOG
Get Started
Menu
BLOG
Get Started

Clamp and Join Sequence Optimization Webinar Invitation

Find the Preferred Sequence for Clamping & Joining Parts

Join DCS for our upcoming webinar to see how dimensional analysis and simulation can provide the results you need to determine manufacturing processes. 

  • When: May 28th, 11 am EST
  • Where: Gotowebinar
  • Register: Fill Out the Short Form to the Right
  • What Else?: This is for the single Sequence Optimization event. If you would like to register for the entire 2020 Webinar Series, simply select the check box at the bottom of the form. 

Reduce lead and launch time by eliminating or minimizing manual join & clamp sequence studies by determining the optimal join and clamp sequence from a candidate set.

 

sequence-optimization-3dcs

inputs-outputs-sequance-optimization-3dcs-1

Using sequence optimization improves the overall process by optimizing the travel path as part of the sequence set. This helps eliminate the problem of optimized sequences that ignore travel path and increase the cycle time to unacceptable levels. The sequence optimization goes through iterations of optimization, improving the overall performance after each analysis. Below you can see the results from an initial study on optimizing the spot weld sequence from the image above: 

sequence-optimizer

Clean & Elegant
Fully Responsive
Clean & Elegant
Fully Responsive

The resulting process sequence provides a method for producing manufactured assemblies as close to nominal as possible given the variation from design gaps, part tolerances, and the impact of join & clamp sequences. 

Join the Webinar